Terminal-to-ECR Cable: Ethernet/Terminal-to-Host Cable: Ethernet

Follow these steps to connect the terminal to your ECR via Ethernet networking and to set up the terminal to communicate with the Moneris Host using Ethernet communication.

Note: Dial or dial backup is not supported using this setup.

Overview setup steps:

[1]  Connect the terminal to your ECR via your Ethernet network.
      

[2]  Connect the iCT250 POS hardware, and power on the terminal (follow the "Setting Up the Terminal Hardware" procedure).
 

[3]  Enable Semi-Integrated mode on the terminal.
      

[4]  Configure the terminal-to-Moneris Host static IP communication parameters on the terminal (continue in the "Getting Started" procedure at step 3).
 

[5]  Configure the terminal-to-ECR communications parameters (Ethernet) on the terminal.

[6]  Initialize and log the terminal onto the Moneris Host (continue in the "Getting Started" procedure at step 4b).
 

[7]  Enable optional features on the terminal as desired.

Note: To enable cash transaction receipt printing from the terminal...

[8]  For information and instructions for using your semi-integrated terminal to perform:

debit/credit and cash transactions...

gift transactions...

loyalty transactions...

end-of-day steps...