Use the Edit Hosts menu to edit Moneris host parameters.
Transactions menu > CONFIGURATION menu (press the green OK key) > Setup menu > Host > Edit Hosts menu
IMPORTANT: Some parameters cannot be edited unless the terminal batch is empty. If the "Edit Not Allwd Batch Not Empty" message appears, perform a Batch Close transaction then try editing the parameter again.
Sets the primary communication type.
Dial - sets dial as the primary communications type
CommServer - sets Ethernet as the primary communications type (default)
Alternate Dial - Do Not Use
ECRi - Do Not Use
If the terminal is configured for Ethernet communications, this parameter can be used to switch the terminal to dial communication if Ethernet communication is not available.
Note: The dial communications cable must be connected to the Duet base and a functioning telephone line before the terminal can successfully use dial communication as a backup.
None - If Ethernet communication is not available, the terminal cannot process transactions (default)
Auto Backup - If Ethernet communication is not available, the terminal will display "IP Connection Failed" then automatically attempt to use the dial line to communicate with the Moneris host.
Prompt Backup - If Ethernet communication is not available, the terminal will display "Use Backup Com Confirm". Select Yes to have the terminal attempt to use the dial line to communicate with the Moneris host OR select No to cancel the transaction. The "IP Connection Failed" message appears, then the terminal display the transactions menu.
Switch Backup - Moneris does NOT recommend using this setting. If Ethernet communication is not available, the terminal will switch to dial communication and stay on dial communications until this parameter is changed to None, Auto Backup or Prompt Backup.
Use Backup - The terminal will always use dial communication.
Sets the primary communication type for settlement. This must match the Comm Link Type parameter value.
Dial - sets dial as the primary communications type
CommServer - sets Ethernet as the primary communications type
Alternate Dial - Do Not Use
ECRi - Do Not Use
Enables/disables the Imprint Card Press OK Key prompt. This prompt may appear during a Purchase or Refund transaction.
Key in 0 to turn the feature off
Key in 1 to turn the feature on
Enables/disables the credit pre-dial feature.
On
Off (Default)