Dial Communications Parameters (Edit CPT Menu)

Use the Edit CPT menu to edit dial communications parameters.

Transactions menu > CONFIGURATION menu (press the green OK key) > Setup menu > Comm > Edit CPT menu

Note: For instructions on navigation through the menus, see The Menu Feature.

IMPORTANT: Some parameters cannot be edited unless the terminal batch is empty. If the "Edit Not Allwd Batch Not Empty" message appears, perform a Batch Close transaction then try editing the parameter again.

Pri Auth Phone

The Moneris phone number is automatically loaded into this parameter during initialization.

If blank, key in the Moneris authorization phone number and press the green OK key.

Sec Auth Phone

The Moneris phone number is automatically loaded into this parameter during initialization.

Pri Sett Phone

The Moneris phone number is automatically loaded into this parameter during initialization.

Sec Sett Phone

The Moneris phone number is automatically loaded into this parameter during initialization.

Pri Init Phone

The Moneris initialization phone number.

If blank, key in the Moneris initialization phone number and press the green OK key.

Sec Init Phone

This is the same value as Pri Init Phone.

Baud Rate

Sets the data transmission rate of the dial modem.

300 BAUD

1200 BAUD (default)

2400 BAUD

4800 BAUD

9600 BAUD

14400 BAUD

Mdm FastConnect

Do Not change this parameter unless directed by Moneris.

Blind Dial

Allows the terminal to dial without checking for a dial tone.

On

Off (default)

Dial Type

Sets the dial type.

Tone (default)

Pulse