The 3G Setup Menu

The terminal communicates with the Moneris Host over a mobile network. This menu allows you to configure the mobile communication parameters (3G Communication is enabled by default). The parameters are listed in the order they appear on the menu.

3G SETUP
APN	Configure only if the SIM card installed in your terminal is labelled with the mobile network name Bell.
LOGIN	Do NOT configure unless directed to do so by Moneris Customer Care.
PASSWORD	Do NOT configure unless directed to do so by Moneris Customer Care.
SIM CODE	Do NOT configure unless directed to do so by Moneris Customer Care.
CONNECT T-OUT	Do NOT configure unless directed to do so by Moneris Customer Care.

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the key.

For information about the keys...

Changing the APN setting for a Bell SIM card

IMPORTANT: If your terminal came with a Rogers SIM card or a Telus SIM card, do NOT follow these steps. Instead, proceed to step 3 under Getting Started.

From the TERMINAL SETUP REQUIRED (or REINITIALIZATION REQUIRED) screen:

1. Press the key.
The MAIN MENU appears.

2. Scroll down to CONFIGURATION, and press the key.
The CONFIG FUNCS menu appears.

3. Scroll down to 3G CONFIG, and press the key.
The 3G SETUP menu appears.

4. Scroll to APN, and press the key.

5. Scroll down to MONBLPUB (use ONLY if a BELL SIM card is installed), and press the key.

NOTE: If your terminal uses a Rogers or Telus SIM card, do not change this setting. Use the default value of MONERIS.

The 3G SETUP menu appears.

6. Press the key once.

7. When 3G CONNECTED PRESS OK prompt appears, press the key.
The TERMINAL SETUP REQUIRED (or REINITIALIZATION REQUIRED) screen appears.

Go back to Getting Started.