- Scroll down: press the
key to
move the highlight bar down.- Scroll up: press the
key to
move the highlight bar up.- Select a highlighted item: press the
key.This menu allows you to configure the Ethernet communication parameters.
Before you set up your terminal to communicate with the Moneris host over high-speed Ethernet, please review the Moneris IP Readiness Checklist (available at moneris.com/checklist) and ensure that your Ethernet service and your Ethernet network are ready to support your terminal.
The functions that appear on this menu vary according to the type of Ethernet communication you select. Not all functions are available for every Ethernet communication type.
The parameters and programs are listed in the order they appear on the menu.
For instructions, go to Communications Configuration and select the Ethernet communication type the terminal will be using.
ETHERNET SETUP |
Allows you to: |
TERMINAL SETUP |
Select
the terminal
type and enter terminal address information. |
DNS SETUP |
enter the
Primary and Secondary DNS addresses
(used only for static IP communication). |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
|
CONNECT T-OUT |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
RETRY CONNECT |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
ERROR REPORT |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
To
navigate through the menus:
- Scroll down: press the
key to
move the highlight bar down.
- Scroll up: press the
key to
move the highlight bar up.
- Select a highlighted item: press the
key.
To access the ETHERNET SETUP menu, from the READY screen:
Press the
key.
The MAIN MENU appears.
Scroll down to CONFIGURATION,
and press the
key.
The CONFIG FUNCS menu appears.
Scroll down to ETHERNET
CFG, and press the
key.
The ETHERNET SETUP menu appears.