Configuring Dynamic Public IP Communication

Dynamic IP over a public network (i.e. the Internet) is the default method of communicating with the Moneris host for the iWL220 terminal. If you plan to use this method then no communication configuration is required.

Note:  The Ethernet cable must be connected to the communications base to which the terminal is registered. If the base is configured to use Ethernet communication and dial backup is available, the terminal will tell the base to use dial communication if Ethernet communication is not available during a transaction. After performing a transaction using dial (as backup), the base will attempt to use Ethernet communication for the next transaction.

If you configured your terminal to use another method of host communication and you wish to revert to using dynamic IP over a public network, refer to Reverting to Dynamic IP over a Public Network.

Go back to Configuring Your Terminal .