To power up the base, simply connect the base to a power outlet as outlined below. These instructions apply to both the communications base and the charge-only base:
IMPORTANT: You must use the exact power adaptor and cable provided with the terminal and base, and use only batteries provided by Moneris Solutions. Failure to do so may affect the operability of, or cause damage to the terminal and/or base and Moneris Solutions shall have no liability whatsoever for a failure to follow these instructions.
1. Insert the
small end (1) of the power cable into the power port labelled with a 
on the base (communications
or charge-only base).
2. Insert the power pack (2) into a power outlet.
The base beeps three times and the green LED
begins flashing.
If this is the first time you have powered up the base, go to Setting up the Hardware.
To power down the base, simply remove the power pack (2) from the power outlet.
To reset the base, power down the base, then wait 30 seconds, and then power up the base.