The Ethernet Setup Menu

This menu allows you to configure the Ethernet Communications parameters.

The functions that appear on this menu vary according to the type of Ethernet Communications you select. Not all functions are available for every Ethernet Communication type.

The parameters and programs are listed in the order they appear on the menu.

For instructions, go to Communications Configuration and select the Ethernet Communications type the terminal will be using.

ETHERNET SETUP

Allows you to:

TERMINAL SETUP

select the terminal type and enter terminal address information
 

HOST SETUP

select the host type and enter host address information
 

DNS SETUP

enter the Primary and Secondary DNS addresses
 

PING

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

CONNECT T-OUT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

RETRY CONNECT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

ERROR REPORT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

 To navigate through the menus:

- Scroll down: press the
F1 key to move the highlight bar down.
- Scroll up: press the
F3 key to move the highlight bar up.
- Select a
highlighted item: press OK.

 

To access the ETHERNET SETUP menu from the READY screen:

1. Press the Admin key.
The MAIN MENU appears.

2. Scroll down to CONFIGURATION, and press OK.
The CONFIG FUNCS menu appears.

3. Scroll down to ETHERNET CFG, and press OK.
The ETHERNET SETUP menu appears.