Configuring Dynamic Public IP Communications

If your terminal will communicate with the Moneris Host over the Internet using Public IP with Dynamic addressing, you will need to set up these parameters.

Each handheld terminal must have its own unique IP address assigned to it.

Note:  If the terminal is configured to use Ethernet communications and dial backup is available, when Ethernet communication is not available the terminal will attempt to use dial communications. After performing a transaction using Dial as backup, the terminal will attempt to use Ethernet Communications for the next transaction.

From the READY screen or the TERMINAL SETUP REQUIRED prompt:

Note:  The Ethernet communications cable must be connected before attempting to communicate with the Moneris Host.

To navigate through the menus:

- Scroll down: press the F1 key to move the highlight bar down.
- Scroll up: press the F3 key to move the highlight bar up.
- Select a highlighted item: press OK.

1. Select the Communications Type

a.  Press the Admin key.
The MAIN MENU appears.

b.  Scroll down to CONFIGURATION, and press OK.
The CONFIG FUNCS menu appears.

c.  Scroll down to GENERAL PARAMS, and press OK.
The GENERAL PARAMETERS menu appears.

If the SWIPE ADMIN CARD prompt appears, swipe the POS Admin card.

d.  Press OK to select COMMS TYPE.
The COMMUNICATION TYPE menu appears.

e.  Scroll to ETHERNET, and press OK.
The ETHERNET SETUP menu appears.

Note:  You may need to press the Can/Ann key once then scroll down to and select ETHERNET CFG to access the ETHERNET SETUP menu.

2. Set up the Terminal Type as Dynamic

a.  Press OK to select TERMINAL SETUP.
The TERMINAL SETUP menu appears.

b.  Press OK to select TERMINAL TYPE.
The TERMINAL TYPE menu appears.

c.  Scroll to DYNAMIC, and press OK.
The TERMINAL SETUP menu reappears.

d.  Press the Can/Ann key once.
The ETHERNET SETUP menu reappears.

3. Set up the Host Parameters as Public

Note: If you change any of the Host parameters after the terminal has been initialized, the terminal will prompt you to perform a re-initialization after the TCP HOST CONNECTION OK message appears.

a. Scroll down to HOST SETUP, and press OK.

Note:  If your terminal uses customized DNS addresses, you will need to enter the DNS addresses.

4. Test the Ethernet Connection

a. Press the Can/Ann key to test the connection.
The TCP HOST CONNECTION OK PRESS OK prompt appears if the connection is up.

b. Press OK to return to the READY screen.

Note: If the RE-INITIALIZATION REQUIRED message appears, you must perform a re-initialization to complete the configuration process.

The terminal is ready to communicate with the Moneris Host over the Internet.

Go back to Configuring Your Terminal .