1. Lift the printer latch up, and then pull back to open the lid and expose the paper well.
2. Insert the paper roll into the paper well with the loose end unrolling from the top of the roll toward the back of the terminal.
Note: If the paper is installed backward, your printouts will be blank.
3. Unroll enough paper to extend at least one inch (2.5 cm) over the top of the lid.
4. Close the lid, and press down to snap it back into place so that the extended paper is pressed securely against the top of the closed lid.
Note: The paper should unroll back over the top and back of the terminal, not unroll over the faceplate.
Warning! DO NOT attempt to manually advance the paper by pulling it as this will damage the printer.
key until the screen illuminates.
Once powered on, proceed to