This menu allows you to configure the Ethernet communication parameters.
The functions that appear on this menu vary according to the type of Ethernet communication you select. Not all functions are available for every Ethernet communication type.
The parameters and programs are listed in the order they appear on the menu.
For instructions, go to Communications Configuration and select the type of Ethernet communication the terminal will be using.
ETHERNET SETUP |
Allows you to: |
TERMINAL SETUP |
Select
the base
type and enter the terminal's address information. |
DNS SETUP |
enter the
Primary and Secondary DNS addresses
(used only for static IP communication). |
Do NOT configure unless directed to do so by Moneris Customer Care. |
|
CONNECT T-OUT |
Do NOT configure unless directed to do so by Moneris Customer Care. |
RETRY CONNECT |
Do NOT configure unless directed to do so by Moneris Customer Care. |
ERROR REPORT |
Do NOT configure unless directed to do so by Moneris Customer Care. |
To
navigate through the menus:
- Scroll down: press the
key to
move the highlight bar down.
- Scroll up: press the
key to
move the highlight bar up.
- Select a highlighted item: press the
key.
For information about the keys...
To access the ETHERNET SETUP menu, from the READY screen:
Press the
key.
The MAIN MENU appears.
Scroll down to CONFIGURATION,
and press the
key.
The CONFIG FUNCS menu appears.
Scroll down to ETHERNET
CFG, and press the
key.
The ETHERNET SETUP menu appears.