The terminal communicates with the Moneris Host over a mobile network. This menu allows you to configure the mobile communication parameters (3G Communication is enabled by default). The parameters are listed in the order they appear on the menu.
3G SETUP |
|
Configure only if the SIM card installed in your terminal is labelled with the mobile network name Bell. |
|
Do NOT configure unless directed to do so by Moneris Customer Care. |
|
Do NOT configure unless directed to do so by Moneris Customer Care. |
|
Do NOT configure unless directed to do so by Moneris Customer Care. |
|
Do NOT configure unless directed to do so by Moneris Customer Care. |
To
navigate through the menus:
- Scroll down: press the
key to
move the highlight bar down.
- Scroll up: press the
key to
move the highlight bar up.
- Select a highlighted item: press the
key.
For
information about the keys...
IMPORTANT: If your terminal came with a Rogers SIM card or a Telus SIM card, do NOT follow these steps. Instead, proceed to step 3 under Getting Started.
From the TERMINAL SETUP REQUIRED (or REINITIALIZATION REQUIRED) screen:
1. Press the key.
The MAIN MENU appears.
2. Scroll down to CONFIGURATION, and
press the
key.
The CONFIG FUNCS menu appears.
3. Scroll down to 3G CONFIG, and press the
key.
The 3G SETUP menu appears.
4. Scroll to APN, and press the key.
5. Scroll down to MONBLPUB (use ONLY if a BELL SIM card is installed), and press the key.
The 3G SETUP menu appears.
6. Press the key once.
7. When 3G CONNECTED PRESS
OK prompt appears, press the
key.
The TERMINAL SETUP REQUIRED (or REINITIALIZATION REQUIRED) screen appears.
Go back to Getting Started.