Configuring Dynamic Public IP Communication
Dynamic IP over a public network (i.e. the Internet) is the default
method of communicating with the Moneris host for the iWL220 terminal.
If you plan to use this method then no communication configuration is
required.
Note:
The Ethernet
cable must be connected to the communications base to which the terminal
is registered. If the base
is configured to use Ethernet communication and dial
backup is available, the terminal will tell the base to use dial communication
if Ethernet communication is not available during a transaction. After
performing a transaction using dial (as backup), the base will attempt
to use Ethernet communication for the next transaction.
If you configured your terminal
to use another method of host communication and you wish to revert to
using dynamic IP over a public network, refer to Reverting
to Dynamic IP over a Public Network.
Go back to Configuring Your Terminal
.