If your base will communicate with the Moneris Host over the Moneris Private IP Network with Dynamic addressing, you will need to set up these parameters for the base.
Before you begin you will need to know:
the Moneris Region in which the terminal and base are located
To navigate through the menus:
- Scroll down: press the
key to
move the highlight bar down.
- Scroll up: press the
key to
move the highlight bar up.
- Select a highlighted item: press the
key.
For
information about the keys...
1. Follow one of the procedures below:
If terminal has NEVER been initialized: |
If terminal has already been initialized: |
From the TERMINAL SETUP REQUIRED screen: a. Set the HOST SETUP parameter as PRIVATE. The terminal returns to the TERMINAL SETUP REQUIRED screen. b. Press the
c. Scroll down to BASE IP SETUP and press the d. Go to step 2 below. |
From the READY screen: a. Set the COMMS TYPE parameter as ETHERNET. b. Set the HOST SETUP parameter as PRIVATE. c. Set the ETHERNET TYPE parameter as DYNAMIC: i. Press the
ii. Scroll down to CONFIGURATION,
and press the
iii. Scroll down to BASE CONFIG,
and press the
If the SWIPE ADMIN CARD prompt appears, swipe the POS admin card. The BASE CONFIG menu appears. iv. Scroll down to BASE IP SETUP,
and press the
v. Press the
vi. Press the
vii. Scroll down to DYNAMIC,
and press the
viii. Press the
d. Go to step 2 below.
|
2. Test the base's connectivity to the Moneris Host:
a. From the BASE IP SETUP menu, press the
key once.
b. When the TCP HOST CONNECTION OK PRESS
OK prompt appears, press the
key
to return to the TERMINAL SETUP REQUIRED screen (or
the READY screen or REINITIALIZATION REQUIRED screen).
4. Go back to "Configuring Your Terminal."