Peel off the protective film (if applicable).
Install the paper roll.
Charge the terminal battery until the charge level reaches 100%:
Dock
the terminal to a powered
base.
OR
Connect the terminal directly to a power source using the direct-to-terminal charge cable.
Before setting up the hardware, consider the most effective location for a communications base.
Register the terminal to the communications base as directed:
If one terminal will communicate with a base using dial, register the terminal.
If one or more dynamic IP terminals will communicate with the base, register the terminal.
If one static IP terminal will communicate with the base, register the terminal.
If multiple static IP terminals will communicate with the one base:
Enable STATIC for the terminal registered in the previous step, and configure its other static parameters (Public Internet - Static or Private Internet - Static).
Enable the other terminals for STATIC following the same Configuring Static procedure used in the previous step, but do not enter any static parameters (i.e., do the steps up to and including 2c. of that procedure).
Register the other terminals to the base.
Do a host connection check for each registered terminal:
Press the Admin keythe key twice.
When the ENTER ADMIN CODE entry screen appears, key in 13 and press the key.
Press the Can/Ann keythe key.
When TCP HOST CONNECTION OK PRESS OK appears, press the key.
Go back to "Getting Started."