Configuring Dynamic Public IP Communication

Dynamic IP over a public network is the default method of communicating with the Moneris host for the iCT250 terminal. If you plan to use this method then no communication configuration is required.  However, you may follow the steps below to confirm that your terminal is set up correctly.

Note:  If the terminal is configured to use Ethernet communication and dial backup is available, when Ethernet communication is not available the terminal will attempt to use dial communication. After performing a transaction using dial (as backup), the terminal will attempt to use Ethernet communication for the next transaction.

From the READY screen (or the TERMINAL SETUP REQUIRED or REINITIALIZATION REQUIRED prompt):

Note:  The Ethernet cable must be connected to the the magic box.

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the  key.

For information about the keys...

1. Set up the Host Parameters as "Public"

2. Select the Communication Type

a.  Press the  key.
The MAIN MENU appears.

b.  Scroll down to CONFIGURATION, and press the  key.
The CONFIG FUNCS menu appears.

c.  Scroll down to GENERAL PARAMS, and press the  key.
The GENERAL PARAMETERS menu appears.

If the SWIPE ADMIN CARD prompt appears, swipe the POS admin card.

d.  Press the  key to select COMMS TYPE.
The COMMUNICATION TYPE menu appears.

e.  Press the  key to select ETHERNET.
The GENERAL PARAMETERS menu appears.

f. Press the key once to access the CONFIG FUNCS menu.

g. Scroll down to ETHERNET CFG and press the key.

The ETHERNET SETUP menu appears.

3. Set up the Terminal Type as Dynamic

a.  Press the  key to select TERMINAL SETUP.
The TERMINAL SETUP menu appears.

b.  Press the  key to select TERMINAL TYPE.
The TERMINAL TYPE menu appears.

c.  Press the  key to select DYNAMIC.
The TERMINAL SETUP menu reappears.

d.  Press the key twice.

e.  When the TCP HOST CONNECTION OK PRESS OK prompt appears, press the  key.

f.  If you are configuring the terminal for the first time, go back to "Configuring Communications."