- Scroll down: press the
key
to
move the highlight bar
down.- Scroll up: press the
key
to
move the highlight bar
up.- Select a highlighted item: press the
key.For information about the keys...
This menu allows you to configure the Ethernet communication parameters for the communications base to which one or more terminals has been registered. Not all functions are available for every Ethernet communication type.
The parameters and programs are listed in the order they appear on the menu.
For instructions, go to Communications Configuration and select the Ethernet communication type the terminal will be using.
BASE IP SETUP |
Allows you to: |
ETHERNET SETUP |
Select
the base type (dynamic or static), and enter the base address
information depending on the base type selected. |
DNS SETUP |
Enter the
base's Primary and Secondary DNS addresses
(used only for static IP communication). |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
|
CONNECT T-OUT |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
RETRY CONNECT |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
ERROR REPORT |
Do
NOT use this function unless directed to do so by Moneris Customer
Care. |
To navigate through the menus:
- Scroll down: press
the
key
to
move the highlight bar
down.
- Scroll up: press
the
key
to
move the highlight bar
up.
- Select a highlighted item: press
the
key.
For information about the keys...
To access the BASE IP SETUP menu, from the READY screen:
1. Press the
key.
The MAIN MENU appears.
2. Scroll down to CONFIGURATION ,
and press the
key.
The CONFIG FUNCS menu appears.
3. Scroll down to BASE CONFIG,
and press the
key.
The BASE CONFIG menu appears.
4. Scroll down to BASE IP SETUP, and press the
key.
The BASE IP SETUP menu appears.