Converting the Communications Base Mode

Follow this procedure to ensure that the base is set for contact-based registration.

1. Dock the terminal on the base to which it is being registered.

2. Press the  key.
The MAIN MENU appears.

3.  Scroll down to CONFIGURATION, and press the  key.
The CONFIG FUNCS menu appears.

4.  Scroll down to BASE CONFIG, and press the  key.

If the SWIPE ADMIN CARD prompt appears, swipe your POS admin card.

The BASE CONFIG MENU appears.

5. Press the  key to select CONVERT BASE.

6. Press the  key to select CONTACT MODE.

7. When PLEASE WAIT appears, wait while the base is converted.  

Note: This process may take several seconds.  Do not undock the terminal.

8. When CONVERSION SUCCESSFUL PRESS OK appears, press the key.

9. Press the key three times.

10. When TERMINAL SETUP REQUIRED or the READY screen appears, follow the "Establishing a Connection to the Base" procedure.