Configuring Dynamic Private IP Communication

If your base will communicate with the Moneris Host over the Moneris Private IP Network with Dynamic addressing, you will need to set up these parameters for the base.

Note:  The Ethernet cable must be connected to the communications base to which the terminal is registered. If the base is configured to use Ethernet communication and dial backup is available, the terminal will tell the base to use dial communication if Ethernet communication is not available during a transaction. After performing a transaction using dial (as backup), the base will attempt to use Ethernet communication for the next transaction.

Before you begin you will need to know:

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the  key.

For information about the keys...

 

1.  Follow one of the procedures below:

If terminal has NEVER been initialized:

If terminal has already been initialized:

From the TERMINAL SETUP REQUIRED screen:

a. Set the HOST SETUP parameter as PRIVATE.

   The terminal returns to the TERMINAL SETUP REQUIRED screen.

b.  Press the  key twice, enter 17, and press the key.
   The BASE CONFIG menu appears.

c. Scroll down to BASE IP SETUP and press the key .
  The BASE IP SETUP menu appears.

d. Go to step 2 below.

From the READY screen:

a. Set the COMMS TYPE parameter as ETHERNET.  

b. Set the HOST SETUP parameter as PRIVATE.

c.  Set the ETHERNET TYPE parameter as DYNAMIC:

i.  Press the  key.
The MAIN MENU appears.

ii.  Scroll down to CONFIGURATION, and press the  key.
The CONFIG FUNCS menu appears.

iii.  Scroll down to BASE CONFIG, and press the  key.

If the SWIPE ADMIN CARD prompt appears, swipe the POS admin card.

The BASE CONFIG menu appears.

iv. Scroll down to BASE IP SETUP, and press the  key. The BASE IP SETUP menu appears.

v.  Press the  key to select ETHERNET SETUP.

vi. Press the  key to select ETHERNET TYPE.

vii.  Scroll down to DYNAMIC, and press the  key.

viii.  Press the key once.
The BASE IP SETUP menu appears.

d. Go to step 2 below.

 

2. Test the base's connectivity to the Moneris Host:

a. From the BASE IP SETUP menu, press the key once.

Note: When the REBOOT TERMINAL screen appears, wait while the terminal reboots.  When the TERMINAL SETUP REQUIRED screen (or READY screen or REINITILIZATION REQUIRED screen) appears, press the  key twice, key in 17, and press the the  key.  If prompted, swipe the POS admin card. When the BASE CONFIG menu appears, scroll down to BASE IP SETUP, and press the  key , then press the key once.

b. When the TCP HOST CONNECTION OK PRESS OK prompt appears, press the  key  to return to the TERMINAL SETUP REQUIRED screen (or the READY screen or REINITIALIZATION REQUIRED screen).

Note: If the REINITIALIZATION REQUIRED screen appears, you must perform a re-initialization to complete the configuration process.

4. Go back to "Configuring Your Terminal."