Enable for RS232 Serial Connection to ECR

From the REINITIALIZATION screen:

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the  key.

For information about the keys...

1.  Press the  key.
The MAIN MENU appears.

2.  Scroll down to CONFIGURATION, and press the  key.
The CONFIG FUNCS menu appears.

3.  Scroll up to SEMI COMM CFG, and press the  key.
The SEMI COMM CFG menu appears.

4.  Scroll down to RS232 and press the  key.

5. Scroll to the appropriate baud rate value, and press the  key.

Note: The default setting is 19200. If necessary, select the baud rate that is supported by your ECR hardware.

6. Wait for the REINITIALIZATION REQUIRED screen to appear.

7. Go back to the overview setup steps (continue at step 6).