Printing the Configuration Parameters Report

When you have finished configuring your terminal, perform this function in order to have a printed record of the terminal’s parameters. Included on the printout are:

•  software revision number (under Term Software Revision)

•  terminal identification information (under Host Initialization Parameters)

•  features enabled from the GENERAL PARAMS menu (under Terminal Configuration)

•  printer setup (under Printer Configuration)

•  all receipt trailer messages, pre-programmed and customized (under Trailer Message)

•  communications parameters (under Dial Comms Parms and Ethernet Parms)

•  communications base parameters (under Base Config)

•  optional features if enabled, for example:

• Purchasing Card Parms

• Multi-Terminal Parms

• Clerk Multi-Subtotals Parms

• Contactless programs (under CVM Limits)

• Signatureless programs (under QPS/VEPS Limits)

From the READY screen:

To navigate through the menus:

- Scroll down: press the F1 key to move the highlight bar down.
- Scroll up: press the F3 key to move the highlight bar up.
- Select a highlighted item: press OK.

1.  Press the Admin key.
The MAIN MENU appears.

2. Scroll down to REPORTS, and press OK.
The REPORT FUNCS menu appears.

3.  Scroll up (it's faster) to CONFIG LIST, and press OK.  
The PRINT TRAILER MESSAGES? prompt appears.

If the SWIPE ADMIN CARD prompt appears, swipe the POS Admin card.

4.  Press he F3 key (NO) to skip the trailer message text   OR  
Press the F1 key (YES) to include the text of all receipt trailer messages (English and French) programmed on your terminal.

Note: This will use quite a bit of paper, especially if there are a number of trailer messages configured.

The terminal displays PRINTING while it prints the report then returns to the READY screen.

If the PRINT ERNEX REPORT? appears ...