Configuring Dynamic Public IP Communications

If your terminal will communicate with the Moneris Host over the Internet using Public IP with Dynamic addressing, you will need to set up these parameters.

From the READY screen or the TERMINAL SETUP REQUIRED prompt:

To navigate through the menus:

- Scroll down: press the
F1 key to move the highlight bar down.
- Scroll up: press the
F3 key to move the highlight bar up.
- Select a
highlighted item: press OK.

1. Select the Communications Type

a.  Press the Admin key.
The MAIN MENU appears.

b.  Scroll down to CONFIGURATION, and press OK.
The CONFIG FUNCS menu appears.

c.  Scroll down to GENERAL PARAMS, and press OK.
The GENERAL PARAMETERS menu appears.

If the SWIPE ADMIN CARD prompt appears, swipe the POS Admin card.

d.  Press OK to select COMMS TYPE.
The COMMUNICATION TYPE menu appears.

e.  Scroll to ETHERNET, and press OK.
The ETHERNET SETUP menu appears.

2. Set up the Terminal Type as Dynamic

a.  Press OK to select TERMINAL SETUP.
The TERMINAL SETUP menu appears.

b.  Press OK to select TERMINAL TYPE.
The TERMINAL TYPE menu appears.

c.  Scroll to DYNAMIC, and press OK.
The TERMINAL SETUP menu reappears.

d.  Press the Can/Ann key once.
The ETHERNET SETUP menu reappears.

3. Set up the Host Parameters as Public

a. Scroll down to HOST SETUP, and press OK.

If the HOST SETUP menu appears...

If the ETHERNET SETUP menu appears...

b. Scroll down to PUBLIC, and press OK.

c. Scroll down to PRODUCTION, and press OK.

The ETHERNET SETUP menu reappears. 

b. Scroll down to SET TYPE, and press OK.

c. Scroll down to PUBLIC, and press OK.

d. Press the Can/Ann key.

The ETHERNET SETUP menu re-appears.

4. Test the Ethernet Connection

a. Press the Can/Ann key to test the connection.
The TCP HOST CONNECTION OK PRESS OK prompt appears if the connection is up.

b. Press OK to return to the READY screen.

The terminal is ready to communicate with the Moneris Host over the Internet.

 

Go back to Configuring Your Terminal .