Configuring Dynamic Private IP Communications

If your terminal will communicate with the Moneris Host over the Moneris Private IP Network with Dynamic addressing, you will need to set up these parameters.

Before you begin you will need to know:

From the READY screen or the TERMINAL SETUP REQUIRED prompt:

To navigate through the menus:

- Scroll down: press the
F1 key to move the highlight bar down.
- Scroll up: press the
F3 key to move the highlight bar up.
- Select a
highlighted item: press OK.

1. Select the Communications Type

a.  Press the Admin key.
The MAIN MENU appears.

b.  Scroll down to CONFIGURATION, and press OK.
The CONFIG FUNCS menu appears.

c.  Scroll down to GENERAL PARAMS, and press OK.
The GENERAL PARAMETERS menu appears.

If the SWIPE ADMIN CARD prompt appears, swipe the POS Admin card.

d.  Press OK to select COMMS TYPE.
The COMMUNICATION TYPE menu appears.

e.  Scroll down to ETHERNET, and press OK.
The ETHERNET SETUP menu appears.

2. Set up the Terminal Type as Dynamic

a.  Press OK to select TERMINAL SETUP.
The TERMINAL SETUP menu appears.

b.  Press OK to select TERMINAL TYPE.
The TERMINAL TYPE menu appears.

c.  Scroll to DYNAMIC, and press OK.
The TERMINAL SETUP menu reappears.

d.  Press the Can/Ann key once.
The ETHERNET SETUP menu reappears.

3. Set up the Host Parameters as Private

a. Scroll down to HOST SETUP, and press OK.

If the HOST SETUP menu appears...

If the ETHERNET SETUP menu appears...

b. Scroll to PRIVATE, and press OK.

c. Scroll to PROD'N PRIVATE, and press OK.

The ETHERNET SETUP menu reappears.

 

 

b. Scroll to SET TYPE, and press OK.

c. Scroll to PRIVATE IP, and press OK.

d. Scroll to SET REGION, and press OK.

e. Scroll to the region your terminal is located in, and press OK.

f. Press the Can/Ann key.

The ETHERNET SETUP menu reappears.

4. Test the Ethernet Connection

a. Press the Can/Ann key to test the connection.
The TCP HOST CONNECTION OK PRESS OK prompt appears if the connection is up.

b. Press OK to return to the READY screen.

The terminal is ready to communicate with the Moneris Host over the Internet.

Go back to Configuring Your Terminal .